Advertisement
Wall Supply
Installation
Shown
Install the Toilet
Position the Toilet
Carefully lower the toilet into place, making sure the water supply line and electrical cord do not
interfere with the toilet when it is in place.
Connect the water supply hose to the supply stop.
Fasten Connect the docking station power cord mark line on the plug upwards.
Connect the optional FM antenna (not shown) to the toilet if needed. In normal case no need to use the
external FM antenna as there's already built-in antenna inside the toilet. However if the environment is causing
unsatisfactory receiving effect, please insert and spread the accessary external FM antenna.
Connect the external speaker wires (not shown) to the toilet if external speakers are installed (RCA plug).
Place the remote control on the docking station.
Connect the power.
Turn on the water supply.
Check for Leaks
NOTE: Once the power is connected, the toilet will automatically enter start-up mode. This process takes
several minutes.
NOTE: If there is a failure during start-up mode, follow the directions on the remote control.
Once the start-up sequence has been completed flush the toilet using the manual buttons on the side
of the toilet.
Let the toilet fully refill and check for leaks.
Kohler Co.
External
Speaker
Connections
Docking
Station Cord
mark line on the
plug upwards
FM Antenna
Connection
Docking
Station
Cord
Cap
FM Antenna
Connection
15
Bushing
Screw
1195109-T01-F
Advertisement
