Advertisement
Determine Mounting Block Location (cont.)
Insert a pencil into the holes in the mounting blocks and mark the center of the holes after positioning the
mounting block.
Remove the mounting blocks.
Position a mounting block in the area indicated on the right side of the template. Align the outside edge of the
mounting blocks with the inside line. Then move parallel 2mm to the inside.
Insert a pencil into the holes in the mounting blocks and mark the center of the holes
after positioning the
mounting block.
At the locations where the centerline in the slots marked on the template and the pencil mark
indicating the hole locations meet, drill a 13mm hole if anchors will be used.
If anchors will be used, insert one of the supplied anchors in each of the holes.
Remove the template.
Kohler Co.
13
1195109-T01-F
Advertisement
