4.
Attach the annunciator and door assembly to back box as shown in Figure 4.25 using the supplied screws.
Surface Mounting
The Model RA-100TR red trim ring kit is available for use when surface mounting the 6860.
1.
Remove the desired knock out.
2.
To properly mount the back box, insert a single screw into the key shaped mounting hole. Do not tighten all the way. See
Figure 4.26.
Place a level on top of the back box, with the back box level insert the rest of the mounting screws.
3.
Run wires to the control panel.
44
Figure 4.25 Attaching Annunciator / Door Assembly to Backbox
Key Shaped
Mounting Hole
Figure 4.26 Back Box Surface Mount Holes
Back Box
Mounting Holes
6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017