Mitsubishi Electric Mr. Slim PUHZ-ZRP35VKA Service Manual page 126

15 DISASSEMBLY PROCEDURE
PUHZ-ZRP35VKA
PUHZ-ZRP35VKAR1
PUHZ-ZRP35VKAR1-ER
PUHZ-ZRP35VKAR1-ET
OPERATING PROCEDURE
1. Removing the top panel, service panel, front panel, back
panel and grille
(1) R emove the top panel fixing screws (4 × 10), one from the
right and two from the left side, and detach the top panel.
(2) R emove 2 service panel fixing screws (4 × 10) and detach
the service panel by pulling it downward. (See Photo 2)
(3) R emove the front panel fixing screws (4 × 10), 3 from the
front, 2 from the right and 2 from the left side, and detach
the front panel.
(4) R emove the back panel fixing screws (4 × 10), 5 from the
right and 2 from the rear side, and detach the back panel.
(5) Remove 2 grille fixing screws (4 × 10) and detach the grille.
2. Removing the fan motor
(1) Remove the top panel. (See Photo 1)
(2) Remove the front panel. (See Photo 1)
(3) Remove 1 nut (M6, left-screw) and detach the propeller.
(4) D isconnect the connector CNF1 on the controller circuit
board in the electrical parts box.
(5) Loosen the clamp for the lead wire in the motor support.
(6) R emove 4 fan motor fixing screws (5 × 20) and detach the
fan motor. (See Photo 4)
OCH527C
PUHZ-ZRP50VKA
PUHZ-ZRP50VKAR1
PUHZ-ZRP50VKAR1-ER
PUHZ-ZRP50VKAR1-ET
Photo 1
Grille
fixing screws
Front panel
fixing screws
Photo 2
Photo 3
Photo 4
Fan motor
(MF1)
126
PHOTOS
Top panel
fixing screws
Top panel
Grille
Front panel
Electrical parts box
Propeller
Nut
Fan motor fixing screws
Fan motor fixing screws
Top panel
fixing screw
Back panel
Service panel
Service panel
fixing screw
Pull down
2 hooks
Clamp
Motor support