Table of Contents
Advertisement
[OPEN]
[CLOSE]
[FREEZE]
Pause the projected image temporarily regardless of the playback of the external device.
1)
Press as to select [FREEZE].
2)
Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen when video is paused.
[WAVEFORM MONITOR]
Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1)
Press as to select [WAVEFORM MONITOR].
2)
Press qw to switch the item.
[OFF]
[ON]
3)
Press the <MENU> button two times to clear.
4)
Press as to select any horizontal line.
5)
Press the <ENTER> button to switch the Select line to either luminance, red, green, or blue.
f Line selection items switch each time the <ENTER> is pressed only when the waveform monitor is
displayed.
"Select line (luminance)"
"Select line (red)"
"Select line (green)"
"Select line (blue)"
Note
f Setting is also available with [FUNCTION BUTTON] (x page 140).
f Waveform monitor cannot be displayed while in [P IN P].
f The waveform monitor turns off when [P IN P] is executed during waveform monitoring.
f The waveform monitor is not displayed when on-screen display is hidden (off).
f Use [3D WAVEFORM MONITOR] to display the waveform monitor with the 3D image.
Adjusting the waveform
Project the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) and
adjust.
Chapter 4 Settings — [DISPLAY OPTION] menu
The projector goes into standby mode with the mechanical shutter opened when the projector is
switched off.
The projector goes into standby mode with the mechanical shutter closed when the projector is
switched off.
Does not display the waveform monitor.
Displays the waveform monitor.
Displayed in white waveform.
Displayed in red waveform.
Displayed in green waveform.
Displayed in blue waveform.
Image position
Image displayable area
ENGLISH - 123
Advertisement
Table of Contents
