Table of Contents
Advertisement
Problems
Cannot control the
projector with Art-Net.
The DIGITAL LINK input
image is not displayed.
3D function is not working.
Left and right images are
reversed (not showing
properly).
Image in the 3D eyewear
flickers.
3D eyewear is not
functioning.
Attention
f If problems persist even after checking the preceding points, consult your dealer.
188 - ENGLISH
Chapter 5 Maintenance — Troubleshooting
f Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
f Is [Art-Net SETUP] set to other than [OFF]?
f Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly?
f Are the connections between the twisted-pair-cable transmitter and the projector or
an external device correctly done?
f Is [DIGITAL LINK MODE] set to [AUTO] or [DIGITAL LINK]? Is it set to
[ETHERNET]?
f Is a signal which is not compatible with a twisted-pair-cable transmitter being input?
f Is the [3D INPUT FORMAT] setting of [3D SETTINGS] correct?
f Check the 3D eyewear settings.
f Is a signal which is supported by the projector being input?
f Is it synchronized? Check the 3D eyewear settings.
f Change the [LEFT/RIGHT SWAP] setting of [3D SETTINGS].
f Are you within the reception range?
f Is the battery for 3D eyewear dead? Charge the battery for the rechargeable 3D
eyewear. Change the battery for the battery type.
f Is the [3D SETTINGS] setting correct?
Points to be checked
Page
―
159
159
―
156
―
103
―
209
―
103
―
―
102
Advertisement
Table of Contents
