Table of Contents
Advertisement
f After configuring settings, your computer or video device or the projector may be required to be turned off and on.
f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or video
device.
[SDI IN]
Set this function in accordance with the signal input to the <SDI IN 1>/<SDI IN 2> terminals.
Setting [SDI LINK]
1)
Press as to select [SDI IN].
2)
Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3)
Press as to select [SDI LINK].
4)
Press qw to switch the item.
[SINGLE LINK]
[DUAL LINK]
[AUTO]
Note
f [SDI LINK] cannot be set when [BACKUP INPUT MODE] is set to [2].
f When [AUTO] is set, either single link or dual link will be automatically selected by reading the payload ID added to the input signal. Single
link will be selected when a payload ID is not added to the input signal.
Setting [SIGNAL LEVEL]
Select the amplitude of the signal to input.
1)
Press as to select [SDI IN].
2)
Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3)
Press as to select [SIGNAL LEVEL].
4)
Press qw to switch the item.
[64-940]
[4-1019]
Setting [BIT DEPTH]
1)
Press as to select [SDI IN].
2)
Press the <ENTER> button.
f The [SDI IN] screen is displayed.
3)
Press as to select [BIT DEPTH].
4)
Press qw to switch the item.
[AUTO]
[12-bit]
[10-bit]
Setting [3G-SDI MAPPING]
1)
Press as to select [SDI IN].
2)
Press the <ENTER> button.
f The [SDI IN] screen is displayed.
Chapter 4 Settings — [DISPLAY OPTION] menu
Sets the SDI1 input and the SDI2 input to single link.
Sets the SDI1 input and the SDI2 input to dual link.
Automatically selects the single link or the dual link.
Normally use this setting.
Select this item when gray is displayed as black.
Automatically select [12-bit] or [10-bit].
Fixes to [12-bit].
Fixes to [10-bit].
ENGLISH - 117
Advertisement
Table of Contents
