Table of Contents
Advertisement
[COMMAND]
[OPERATING MODE]
[P IN P]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
*2 If you change the settings while using the projector, the duration until the light source luminance decreases by half may shorten or the
luminance may decrease.
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. (x page 135)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.
[RS-232C]
Set the communication conditions of the <SERIAL IN>/<SERIAL OUT> terminal. Refer to "<SERIAL IN>/<SERIAL
OUT> terminal" (x page 199).
Setting the communication condition of the <SERIAL IN> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [INPUT SELECT].
4)
Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5)
Press as to select [(IN) BAUDRATE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
138 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
[NORMAL]
[ECO]
[LONG LIFE1]
[LONG LIFE2]
*2
[LONG LIFE3]
[USER1]
[USER2]
[USER3]
[OFF]
[USER1]
[USER2]
[USER3]
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Description
Prioritizes luminance.
Controls the power to increase the life of the light source with higher
luminance.
Controls the power to increase the life of the light source although
the luminance is lower than that of [ECO].
Controls the power to increase the life of the light source although
the luminance is even lower than that of [LONG LIFE1].
Controls the power to increase the life of the light source to the
maximum although the luminance is even lower than that of [LONG
LIFE2].
Controls the power with the setting set to [USER1].
Controls the power with the setting set to [USER2].
Controls the power with the setting set to [USER3].
P IN P function is not used.
Lays out the sub-screen with the settings of [USER1].
Lays out the sub-screen with the settings of [USER2].
Lays out the sub-screen with the settings of [USER3].
Advertisement
Table of Contents
