Error Messages And Troubleshooting - Omron BP7250 Instruction Manual

7. Error Messages and Troubleshooting

If any of the below problems occur during measurement, check to make
sure that no other electrical device is within 12 inches (30 cm). If the
problem persists, refer to the table below.
Display/Problem
appears or the arm
cuff does not inflate.
Possible Cause
The [START/STOP]
button was pressed
while the arm cuff is not
applied.
Air plug is not completely
plugged into the monitor.
The arm cuff is not
applied correctly.
Air is leaking from the
arm cuff.
35
Solution
Press the [START/
STOP] button again to
turn the monitor off. After
inserting the air plug
securely and applying
the arm cuff correctly,
press the [START/STOP]
button.
Insert the air plug
securely. Refer to sub-
section 2.4.
Apply the arm cuff
correctly, then take
another measurement.
Refer to sub-section 2.4.
Replace the arm cuff
with a new one. Refer to
section 9.