Belkin F1DN108K-3 User Manual page 25

InsTallaTIon
SECTIONS
Table of Contents
Mouse speed setting
Constant mouse cursor speed is essential for system usability. Having
several systems each with a different cursor "ground speed" is detrimental
for the user. Belkin's Belkin Secure KM calculates and adjusts the cursor
speed across different displays and computers using the geometry and
display settings entered by the administrator.
In addition, the Switch settings include a global speed setting with input
values between 1 and 10, which can be changed to adjust the cursor speed
for all displays. Typical initial setting of cursor speed is 5. After initial use,
the exact value can be set based on user inputs.
To increase mouse speed, press CTrl, CTrl, f11, +
To decrease mouse speed, press CTrl, CTrl, f11, -
sCs enabled / disabled setting
Through the SCS enabled / disabled setting, you can disable the mouse
cursor tracking function. Once SCS is disabled – the Switch will enable
channel selection only through:
1. Front panel push-buttons;
2. Keyboard shortcuts; and:
note: This setting is enabled by default.
Belkin Secure 4/8 port KM Switch User Manual
®
1 2
Multiple-Head display driver Installation
To enable proper KM interaction with computers having multiple heads
(more than one display), the Belkin Secure KM Mouse Filter driver software
must be installed. This driver is available in an executable .EXE file that
can be installed on the target computer. Driver can be loaded from Belkin
website. If internet access is not allowed - contact Belkin to order the KM
Switch programming Kit (software CD is included in that kit.
Keyboard shortcuts
The following table describes the keyboard shortcuts available:
Key Sequence
CTrl, CTrl,
f11, r
CTrl, CTrl,
f11, f
CTrl, CTrl,
f11, u
CTrl, CTrl,
f11, +
CTrl, CTrl,
f11, -
CTrl, CTrl,
f11, d, c
CTrl, CTrl,
f12
23
3 4
Name
Reset to Factory
defaults
Freeze
Unfreeze
Increase mouse
speed
Decrease mouse
speed
Setup mode
Last loaded
configuration
5 6
Description
Device will reset to factory defaults with all
settings and configuration deleted completely.
Disable SCS. Switching between systems will not
be possible via mouse movement.
Enable SCS. Switching between systems will be
possible via mouse movement.
Mouse speed will be increased.
Mouse speed will be decreased
In the next boot after pressing this key
combination the device will boot into setup mode
allowing him to communicate with configuration
utility.
Revert to the last externally loaded configuration
(configuration loaded via configuration utility).
7