Belkin F1DN108K-3 User Manual page 20

InsTallaTIon
SECTIONS
Table of Contents
step 3 – Powering up
3.1 Power on all of the monitors.
3.2 Connect the Belkin Secure KM to the cable DC plug of the 12V 1.5A
external AC/DC power supply (F1DN104K-3).
3.3 Connect the power cable IEC power plug to KM switch AC power inlet
and then the power plug to a nearby wall outlet. Turn on the power
switch located near the AC power inlet.
3.4 Power up all the attached computers, and check for display and
peripheral functionality. All computers can be powered on.
notes: Your computers should recognize the Belkin Secure KM and
automatically install the HID USB driver if necessary.
You should be able to move the mouse cursor on the primary display
connected to computer #1. Check to see that the keyboard and mouse are
working normally on each computer. Repeat this check with all occupied
ports to verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that computer
and reboot. If the problem persists, please refer to the Troubleshooting
section in this User Manual.
Belkin Secure 4/8 port KM Switch User Manual
®
1 2
Color Code Chip Installation
The Belkin Advanced Secure KM Switch's port-selector buttons can be color-
coded for easier identification. Refer to the installation instructions below.
note: You may have to remove the existing black color chip first.
Port name label
The included network-name labels can be placed in the area underneath the
port-selector buttons for port identification. Blank labels are also provided.
18
3 4
Insert color chip
5 6
Remove color chip with
a standard paperclip
7