FPI P36 Owners & Installation Manual page 60

Note: The facing material has to go on after
the unit is set.
1) Remove Glass Door. Refer to P36 Manual.
2) Remove 2 screws and bracket as indicated
(refer to Diagram 3).
Remove
bracket
Diagram 3
Remove both
screws
3) Install On/Off switch (refer to Diagram 4).
Diagram 4
4) Place bracket under the Flange. Secure
with 2 screws as indicated in Diagram 5.
Diagram 5
60
5) Loosen the 3 x #8 Phillips Head Screws lo-
cated on the inside top of the outer frame of
the appliance (refer to Diagram 6).
3 x #8
Phillips
Diagram 6
6) Install Top Support Frame
Slide in the Top Support Frame using the
slots as a guide. Secure and re-tighten the
screws to the unit.
On/Off
Switch
Control
Mounting
Bracket
View of backside of Top Support
REGENCY
7) Side Support Frame
8) Attach Top and Side Support Frame
Cut-Outs
Note: The Nailing Strips can be adjusted,
depending on the facing material (as indicated
in Diagram 8).
Frame.
9) Optional
10) Change in Logo
FPI P36-4 Zero Clearance Direct Vent Gas Fireplace
®
OPTIONS
a) Mount Side Support Frame to unit as
shown in Diagram 7, then secure with 2
screws on each side.
b) Repeat step on the other side.
Diagram 7
a) Ensure the Side Supports are aligned with
the corresponding hole on the Top Support
Frame, then secure with 1 screw.
b) Repeat step on the other side.
1/2"
Facing
Material
Diagram 8
1" Facing Material
Install Optional 3-Panel Arch Door. (Refer
to Install 3-Panel Arch Door Instruction
Sheet).
Replace existing logo with Regency logo.