Troubleshooting; Self Diagnosis Display - Samsung VP-M2100S Owner's Instruction Book

Troubleshooting

Self Diagnosis Display

Display
Not enough free space Not enough free space for saving files .
Corrupted file The file is corrupted.
Paper error The paper is insufficient.
Ink error Ink is low.
File Error! The file is wrong.
Communication Error! The error is occurred while transferring data.
Sleeping now... Power saving mode works.
Low battery Battery is low.
Holding the key The HOLD switch is locked.
Card error The Memory Card is corrupted.
Not formatted Format the Memory Card.
Write error Failed to write.
Read error Failed to read.
Not supported format The format is not supported.
Write protected Memory Card is protected to write.
MPEG decoding Error The video file is corrupted.
✤ If these instructions do not solve your problem, contact your nearest Samsung dealer or authorized service centre/personnel.
Symptom
No power is supplied
Date/Time is wrong
Focus does not adjust automatically
The Memory Card will not
load properly
Informs that...
Possible Causes
The power is not connected properly
The battery is dead
The battery is too cold
The Date/Time is not set
Focus is set to manual mode
Recording was done in a dark place
Lens is covered with condensation
The Memory Card is in wrong position
Something fills in the MUILTI CARD slot
Check the space of internal memory or the external memory.
Delete the corrupted file.
Check the paper in the printer. If there is no paper, insert the paper.
Check if the ink or toner is low.
Check that the file is JPEG.
Disconnect the USB cable and connect it again.
Press any button to return to previous menu.
Charge the Battery Pack or connect the AC Power Adapter.
Unlock the HOLD switch and operate the CAM.
Format the Memory Card or replace it with new one.
Format the Memory Card.
Check the memory space or format the memory.
Delete the file.
The AVI or JPEG file that is not supported. Check the supported file.
on page 29.
Unlock the Memory Card. (except MMC)
Delete the corrupted file.
Connect the AC Power Adapter properly, page 23
Replace the dead Battery Pack
Warm up the battery or move to warmer place
Set the Date/Time, pages 92-93
Set focus to AUTO
Use strobe or lit the place
Clear the lens and check the focus
Insert the Memory Card properly, page 33
Clear the MUILTI CARD slot
ENGLISH
Action
Measure
125 125