Troubleshooting - Samsung SCD67 Owner's Instruction Book

IENGLISHI
Troubleshooting
,b Before contacting a service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call
Self Diagnosis Display
Display Blinking Informs that... Action
[_ sIow the battery pack is almost discharged. Change to a charged one,
fast the battery pack is fuIly discharged. Change to a charged battery.
r_q 2MIN sIow When the remaining time of the tape is about 3 minutes. Prepare a new one.
TAPE END no the tape reached its end. Change to a new one.
TAPE sIow there is no tape in camcorder, insert a tape.
TAPE sIow the tape is protected to record, if you want to record, release the protection,
sIow the camcorder has some mechanical fault. 1. Eject the tape.
C.EMG 2. Set to OFE
D.EMG 3. Detach the battery.
L.EMG 4. Reattach the battery.
R.EMG * If unresoIved contact your local service
representative.
DEW sIow moisture condensation has formed in the camcerder, see below.
Moisture Condensation
If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the camcorder, on the surface of the tape,
or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly.
To prevent possible damage under these circumstances,the camcorder is fitted with a moisture sensor,
If there is moisture inside the camcorder, "DEW" is displayed.
If this happens, none of the functions except cassette ejection will work,
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry warm room.