Generac Power Systems EcoGen G0070340 Installation Manuallines page 36

Control Panel Start-Up/Testing
NOTE: The USB port is intended for use with a USB
flash drive only. The USB port is not intended for
charging or powering any devices such as phones or
Display Reads
Language
- English
Activate me (ENT) or
ESC to run in manual
To Activate go to
www.activategen.com
32
Table 7-1. Activation Chart
+
LED lights. Do not connect any consumer electronics to
the USB port
Use arrow keys to
scroll to desired
Language can be changed later using
language.
the EDIT menu.
Press ENTER to
select.
If ESCAPE is pressed instead of
ENTER, the generator will only run in
manual mode (for test purposes) and
NOT ACTIVATED will be displayed.
Press ENTER to begin You will need to remove the 7.5 amp
the activation process. generator control panel fuse AND
disconnect the T1, N1, and N2
connector in the external connection
box (if equipped); or disengage all
connected loads.
If you do not have your
activation code, go to
www.activategen.com
or call 1-888-
9ACTIVATE
(922-8482 US & CA
only).
If you already have
your activation code,
wait 3–5 seconds for
the next display.
Installation Guidelines For 60 Hz EcoGen™ Generators
Troubleshooting