Lp Vapor Installation (Typical) - Generac Power Systems EcoGen G0070340 Installation Manuallines

LP Vapor Installation (typical)

LP BTU = ft LP BTU = ft
Megajoules = m Megajoules = m
A A BTU and pressure decal BTU and pressure decal
B B Minimum distance from rear obstruction Minimum distance from rear obstruction—see
C C Manual shutoff valve (pressure port optional) Manual shutoff valve (pressure port optional)
D D Pipe nipple (field supplied) Pipe nipple (field supplied)
E E Flexible fuel line Flexible fuel line
F F Check distance with gas provider. See Check distance with gas provider
G G Reinforcing rod Reinforcing rod
H H Clamp Clamp
J J Secondary fuel pressure regulator Secondary fuel pressure regulator
K K Manual shutoff valve Manual shutoff valve
L L Primary fuel pressure regulator Primary fuel pressure regulator
M M Fuel tank—sized large enough to provide required BTUs for generator and Fuel tank—sized large enough to provide required BTUs for generator and
ALL connected appliance loads. Be sure to correct for weather evaporation. ALL connected appliance loads. Be sure to correct for weather evaporation.
Installation Guidelines For 60 Hz EcoGen™ Generators
F
B
C
A
D
E
H
3 3
/h X 2500 /h X 2500
3 3
/h X 93.15 /h X 93.15
Figure 5-7. LP Vapor Installation (typical)
G
J K
Site Selection
Site Selection .
Fuel Conversion / Gas Connections
M
L
001809
23