Heath Zenith Secure Home DUALBRITE SH-4300-BK4-B Manual page 4

Black to Black
White to White
Ground
to Ground
One Motion Sensing Light
Ground to Ground
Black to Black
White to White
Two Motion Sensing Lights (Working Independently)
Other Wiring Options
This fixture can be wired to control another standard
or motion sensing light fixture(s). See the following
wiring diagrams for proper connections.
Note: All wiring should be run in accordance with
the National Electrical Code through conduit or
another acceptable means. Contact a qualified
electrician if there is any question as to the
suitability of the system.
When controlling an additional light fixture(s), the
maximum wattage of the motion sensor on this
fixture should be observed. See illustration below
for an example of a maximum lamp wattage load
calculation.
Maximum Load for
Motion Sensor –
200 Watts
IMPORTANT: When determining the maximum
lamp wattage rating of the fixture to be controlled,
refer to the maximum lamp wattage label on the
fixture and not the wattage rating on the lamp(s)
currently installed in the fixture.
Black to Black
Red to Black
Motion Sensing Light
Wiring Motion Sensing Light to Control Standard
Ground to Ground
Black to Black
Red to Black
Motion Sensing Light
Wiring Motion Sensing Light to Control Another
Motion Sensing Light
4
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
CONTROLLING Fixture
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
CONTROLLED Fixture 1
TOTAL Load for
Motion Sensor –
200 Watts
White to White
Ground to
Ground
Standard Light Fixture
Fixture
Black to Red
and Black
White to White
Controlled Motion
Sensing Light
200478-02