Cable Service With Vcr - Zenith H20H52DT Installation And Operating Manual

Cable Service (CATV) with VCR Hook Up
Connect Cable service and a VCR to the HealthView TV.
Locate the Antenna/Cable in jack on
1
the back of the VCR.
Connect the wire that runs from the cable
2
service wall jack, according to one of the
diagrams to the right.
Remove the back of the optional remote
3
and put in two AA batteries.
Plug in the TV. The HealthView TV is
4
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC power.
Go to page 11 to Auto Program the TV.
5
Leave the VCR and the television tuned
to channel three or four and use the
cable box to change channels.
Back of
Remote
In
Cable TV
Wall Jack
Out
output
switch
3 4
Cable Box
ANTENNA
TV SPEAKER
CABLE
M.P.I.
PILLOW SPEAKER
TV Back Panel
(Expanded View)
Cable TV
Wall Jack
VCR Back
VCR Back AV Panel
output
In
switch
Video
Out
VIDEO IN
SPEAKER OUT
AUDIO IN
3 4
Audio
Page 9