Cable Service (CATV) Hook Up
Connect cable service to the HealthView TV.
Locate the Antenna/Cable jack on the
1
back of the HealthView TV.
Connect the cable service wire that runs
2
from the wall, according to one of the
diagrams to the right.
Remove the back of the optional remote
3
and put in two AA batteries.
Plug in the TV. The HealthView TV is
4
designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to
operate it on DC power.
5
Go to page 11 to Auto Program the TV.
If you're using a cable box, leave the TV on
channel 3 or 4 and use the cable box to
change channels.
If you're using a cable box, Auto Program
might only find the channel the cable
service is on (usually channel 3 or 4).
Cable TV
Wall Jack
Back of
Remote
In
Out
RF Coaxial Wire
(75ohm)
Cable TV
Wall Jack
Cable Box
output
switch
3 4
RF Coaxial Wire
(75 ohm)
TV Back
ANTENNA
TV SPEAKER
CABLE
VIDEO IN
SPEAKER OUT
M.P.I.
PILLOW SPEAKER
AUDIO IN
TV Back Panel
(Expanded View)
TV Back
ANTENNA
TV SPEAKER
CABLE
VIDEO IN
SPEAKER OUT
M.P.I.
PILLOW SPEAKER
AUDIO IN
TV Back Panel
(Expanded View)
Page 7