Cable Service With Vcr - Zenith B19A23DCOM Operating Manual And Warranty

Hook Up Your Cable (CATV) and VCR
Connect cable service and a VCR to your
Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
4
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 12 to Auto Program
5
your Entertainment Machine.
Leave your VCR and your television
tuned to channel three and use
the cable box to change channels.
Remember, when screwing in RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
P A G E 1 0
Cable TV
wall jack
In
output
Out
switch
RF coaxial cable (75ohm)
TV back
OUT
R Audio L/Mono
ANT IN
IN
75 Ω
Cable with Cable Box and VCR
Cable TV
wall jack
Cable box
In
output
Out
switch
RF coaxial cable (75 ohm)
TV back
OUT
R Audio L/Mono
ANT IN
IN
75 Ω
Cable with VCR
VCR back
Cable box
3 4
VCR back AV panel
output
In
switch
Out
Video
RF coaxial wire
(75ohm)
not included
with TV
Video
VCR back
3 4
VCR back AV panel
In
Out
RF coaxial wire
(75 ohm)
not included
with TV
Video
3 4
Audio
A/V cables
not included
with TV
output
switch
3 4
Video Audio
A/V cable
not inclu
with TV
206-3480