Antenna - Zenith H20H52DT Installation And Operating Manual

Antenna Hook Up
Connect an off-air antenna to the HealthView TV.
Locate the Antenna/Cable jack on the
1
back of the HealthView TV.
Connect the antenna wire that runs from
2
the wall to this jack, according to one of
the diagrams shown to the right.
Remove the back of the optional remote
3
and put in two AA batteries.
Plug in the TV. The HealthView TV is
4
designed to operate on standard
current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Power.
Go to page 11 to Auto Program the TV.
5
If you have a 75 ohm RF cable, then you
don't need any adapters.
A 300 to 75 ohm adapter is not included
with the Zenith
Mini Glossary
The wire that comes from an off-air antenna or cable service provider. Each end looks
75 OHM RF
CABLE like a hex shaped nut with a wire sticking through the middle, and it screws onto the
threaded jack on the back of the TV.
300 TO 75 A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They
are usually about an inch long with two screws on one end and a round opening with a
OHM
wire sticking out on the other end.
ADAPTER
Page 6
Back of
Remote
HealthView TV.

Antenna

Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75 ohm)
TV Back
ANTENNA
TV SPEAKER
CABLE
VIDEO IN SPEAKER OUT
M.P.I.
PILLOW SPEAKER
AUDIO IN
TV Back Panel
(Expanded View)
TV Back
ANTENNA
TV SPEAKER
CABLE
VIDEO IN SPEAKER OUT
M.P.I.
PILLOW SPEAKER
AUDIO IN
TV Back Panel
(Expanded View)