Table of Contents
Advertisement
TABLE OF CONTENTS
Use the steps outlined below as a setup guide and to determine the TV features
that will require adjustment for the needs of the end user.
Safety Warnings
Table of Contents
Step 1. Hook Up the HealthViewTV
TV and other Equipment Hookups
Step 2. Channel Search and Reception Setup
(Select Antenna, or cable service then do
Optional Installer's Remote Key Functions
Step 3. Customize the TV's Features
Descriptions of the menus on the TV
Setting Add/Del/Blank
Optional Installer and Patient Remote Controls:
Shown herein are optional remote controls that can be used by the installer and the patient. Be
advise that these remote controls are NOT included with this TV. However, these remotes can be
purchased separately, see your Zenith Electronics dealer.
Installer/Hospital Note:
Pages 44, 45, 46, 47 and 48 contain information and menus which the patient can use to operate the
TV. It is recommended that these four pages be copied and included with the literature packet that the
hospital provides to the patient.
Purchase the Optional Installer's Remote and Clone Programmer
To perform a normal installation set up, you need an installer's remote such as the HP602, and the
LT2000 Quickset II Clone Programmer-both are shown and described in later sections. The installer
remote allows access to the Installer menus, User menus, and Source/Channel Bank keys. The installer
remote has Menu, Select, and Adjust, and Channel Bank Keys. The LT2000 Quickset II Clone
Programmer is used to duplicate a TV's setup and install it on another identical TV.
See your Zenith Dealer.
Design and specifications subject to change without prior notice.
2
3 - 4
5
6
7
8
9
10
Patient Operation Section (Copy for patient usage)
Optional Patient Remote Key Functions
11
Optional Patient Remote
12
Patient Menus and On-Screen Displays
13
14
Warranty for HealthView Series TVs
15
16
18
17
19
21
22
23 - 24
25 - 26
27
28 - 30
31 - 38
39 - 43
44
45
46 - 47
48
49
50
51
Back
Cover
Page 5
Advertisement
Table of Contents
