Table of Contents
Advertisement
Control Panel
Firmware
Do not power down or remove the memory card
during a firmware upgrade.
The printer firmware is saved in a Flash EPROM. You can update the
firmware using the following functions:
Firmware upd.: Copy a firmware file from a computer connected to one
■
of the interfaces of the Brady IP Printer. Refer to Firmware Update via
Interface on page 54. Brady Support can provide additional information
about current firmware available on the Brady website.
Firmw. fr. card: Copy a firmware file from a memory card. Refer to
■
Firmware Update from Memory Card on page 55.
Firmware Update via Interface
1. Press the menu key.
2. Select Service > Firmware upd. menu.
3. Press the
4. The Firmware-Upd message appears in the display.
5. Press the
6. If Firmware upd. is protected via a PIN, use the
to enter the code number and confirm with the
7. Open the DOS input window on the PC.
8. Configure the serial interface of the PC with the mode command. Enter
the command mode com1: baud=115200 parity=n data=8 stop=1, for
example.
9. Send the firmware file (e.g. 304_6811.x2) to the printer. Enter the
command copy /b 304_6811.x2 com1:, for example.
10. A progress indicator is displayed while the firmware is being copied. OK
appears in the display once copying is successfully completed.
11. Press the
54
key.
key.
key.
NOTICE
,
,
and
key.
keys
Advertisement
Table of Contents
