Loop Remix - Yamaha RS7000 Owner's Manual

6 CREATE TO
(Destination Key Number)
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
OK
7
......................................................................................[F3]
Saves the processed sample to the specified destination key
number.
10 STEREO TO MONO
Converts a stereo sample to a mono sample.
4
1 2 3
[F2]
[Knob 1] [Knob 2]
[Knob 3]
SAMPLE (Sample Number)
1
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be converted.
KEY (Key Number)
2
............................................[Knob 2]
[Settings] C-2 ~ G8
Specifies the key number of the sample to be converted.
NOTE
This parameter is not available when the speci-
fied sample is a Pitched Voice.
TYPE
3
.........................................................................[Knob 3]
[Settings] L+R>MONO, L>MONO, R>MONO
L+R>MONO ...... The left and right channels of the ste-
reo sample are mixed and converted
to a mono sample.
L>MONO........... The left channel on the stereo sample
is converted to a mono sample.
R>MONO .......... The right channel on the stereo sam-
ple is converted to a mono sample.
Specifies which channel, or both channels, of the stereo sam-
ple will be converted to a mono sample.
AUDITION
4
.......................................................................[F2]
Plays the specified sample.
Plays the processed sample if pressed after [F4] (DO!) is
pressed to convert the sample.
5
.............................[Knob 2]
6
7
6
5
[F3]
[F4]
...........................[Knob 1]
8
Slices and randomly rearranges the selected sample while also
changing the sound of some portions to create totally new varia-
tions.
This job is effective when used with accurately-extracted 1 or 2-
measure break-beats or phrase samples. Before using the Loop
Remix job, set the loop start and end points in the Trim page, and
then use the sample Extract job.
1
DO!
................................................................................... [F4]
Executes the job.
CREATE
......................................................................... [F3]
Saves the processed sample to the target sample number,
overwriting the original sample.
If the original sample is a Pitched Sample it will be overwrit-
ten at this point. If the original sample is part of a Sample Kit
Voice a key-number selection page will appear.
7
[Knob 2]
CREATE TO
(Destination Key Number)
[Settings] C-2 ~ G8
Specifies the key number to which the processed sample will
be saved.
OK
..................................................................................... [F3]
Saves the processed sample to the specified destination key
number.

11 LOOP REMIX

5
1 2 3
[F2]
[Knob 2] [Knob 3]
[Knob 1]
SAMPLE (Sample Number)
[Settings] 001 ~ 128, C001 ~ C128
Specifies the sample voice to be remixed.
4. The Sample Jobs
8
[F3]
............................ [Knob 2]
7 4 6
[F3]
[F4]
[Knob 4]
.......................... [Knob 1]
RS7000 251
5