Preparation And Setup; Power Connection; Connecting To Audio Equipment - Yamaha RS7000 Owner's Manual

Preparation and Setup

Preparation and Setup
Power supply and other equipment connections will be described in this section.

Power Connection

WARNING
• Be sure that the RS7000's power switch is OFF
before you connect the cord.
• Make sure your RS7000 is rated for the AC voltage
supplied in the area in which it is to be used (as
listed on the rear panel). Connecting the unit to the
wrong AC supply can cause serious damage to the
internal circuitry and may even pose a shock haz-
ard!
• Use only the AC power cord supplied with the
RS7000. If the supplied cord is lost or damaged and
needs to be replaced, contact your Yamaha dealer.
The use of an inappropriate replacement can pose a
fire and shock hazard!
• The type of AC power cord provided with the
RS7000 may be different depending on the country
in which it is purchased (a third prong may be pro-
vided for grounding purposes). Improper connection
of the grounding conductor can create the risk of
electrical shock. Do NOT modify the plug provided
with the RS7000. If the plug will not fit the outlet,
have a proper outlet installed by a qualified electri-
cian. Do not use a plug adaptor which defeats the
grounding conductor.
• The RS7000 is designed for use with a grounded
line (three-prong outlet). The power cord includes a
grounding pin to prevent electrical shock and dam-
age to equipment.
Connect the supplied power cord to the AC inlet on the rear
panel. Then plug the other end of the cord into a 3-prong wall
outlet.
22 RS7000
The RS7000 has no internal amplifier or speakers of its own. To
monitor the sound of the RS7000, connect headphones, powered
speakers, or other playback equipment as required.
I Headphones
If you are using headphones, connect them to the rear panel
PHONES (headphones) jack. When using headphones, adjust the
MASTER VOLUME control to an appropriate level that will not
harm your hearing. The rear-panel OUTPUT L/MONO and R
jacks are active even when headphones are connected.
INPUT
R
I Powered Speakers
Connect a pair of powered speakers (such as the Yamaha CBX-
S3) to the output jacks (L/MONO, R) using appropriate connec-
AC INLET
tion cables. If you are connecting only one powered speaker, use
MODEL SER. NO.
the L/MONO jack.
M

Connecting to Audio Equipment

CAUTION
Connections with external equipment must be made
with the power of the RS7000 and peripheral equip-
ment turned off. Making connections with the power
on may damage your amp or speakers.
OUTPUT
L R L/MONO PHONES
THAT MAY CAUSE UNDESIRED OPERATION.
INPUT OUTPUT
SW CONTRAST R L R L/MONO PHONES