Sample Editing - Yamaha RS7000 Owner's Manual

3. Sample Editing

Samples can be edited in this mode.
NOTE
• Samples are digitally recorded audio waveform data complete with "sample parameters" which define how
the sample will play back.
• Before using the sample edit mode be sure to turn the UTILITY mode Memory Protect function OFF (Page
257). If the Memory Protect function is ON, "Memory Protected" will appear on the display when the [SAM-
PLE EDIT] button is pressed and it will not be possible to enter the edit mode.
• If no sample is assigned to the currently selected track, the sample job list page will appear when the
[SAMPLE EDIT] button is pressed and it will not be possible to enter the edit mode.
• Sample Edit cannot be accessed from the PATTERN Chain mode.
• The "Undo" function cannot be used to undo sample edit operations.
Sample Edit Features
G Samples can be directly edited in the Sample Edit
mode.
G Samples assigned to any track of the current pattern
or song can be edited.
G Samples have four Play Modes which determine how
they are played back.
The play mode is specified in the Sample Edit Sample
Parameter page (Page 242). The four play modes are listed
below:
FORWARD.........The sample plays from the start point to
the end point.
REVERSE ...........The sample plays in reverse from the end
point to the start point.
LOOP ..................The sample loops repeatedly from the start
point to the end point.
ATK+LOOP........After playing from the start point to the
end point, the sample loops between the
loop start point and the end point.
START
FORWARD
REVERSE
LOOP
ATK+LOOP
START(ATCK)
END
START(LOOP)
Sample Edit Procedure
In the PATTERN or SONG Play mode, stop playback of the
1.
sequence and then select the track to which the sample voice
you want to edit is assigned (Page 73, 183).
Press [SAMPLE EDIT] to go to the Trim page.
2.
If the selected sample voice is a Sample Kit Voice, press the
3.
[KEYBOARD] button so that its indicator lights, and then
press the key on the keyboard corresponding to the sample
you want to edit.
Use [Knob 1] ~ [Knob 4] to change the settings as required.
4.
Press [SAMPLE EDIT] to go to the Sample Parameter page.
5.
Use [Knob 1] ~ [Knob 4] to change the settings as required.
6.
Press [EXIT] to go back to the Trim page, and then again to
7.
return to the original display.
Display Parameters
[1] Trim Page
8
2 6
1 3
[F1] [F2]
[Knob 2]
[Knob 1]

3. Sample Editing

[SAMPLE EDIT]
9
7
4 5
[F4]
[Knob 3] [Knob 4]
RS7000 241
5