Reconnecting To A Wireless Access Point Using The Scansnap Wps Button (Ix500 / Ix100) - Fujitsu ScanSnap iX1400 Basic Operation Manual

Reconnecting to a Wireless Access Point Using the
ScanSnap WPS Button (iX500 / iX100)
If the Wi-Fi indicator lights up or flashes in orange, reconnect the ScanSnap to a WPS compatible
wireless access point. The reconnection can be established easily by pressing the WPS button on
the ScanSnap.
ATTENTION
Perform the following before you connect using the WPS button.
l If the ScanSnap Wireless Setup Tool is running while the ScanSnap is being connected to the
computer with a USB cable, exit the ScanSnap Wireless Setup Tool.
l If scanning is currently being performed from ScanSnap Manager or a mobile device, end the
scanning operation.
HINT
Button names and operating procedures may differ depending on the wireless access point. For
details, refer to the manual for your wireless access point.
1.
Turn on the Wi-Fi switch on the back of the ScanSnap.
iX500
Wi-Fi
OFF
iX100

Reconnecting to a Wireless Access Point Using the ScanSnap WPS Button (iX500 / iX100)

ON
Wi-Fi switch
Wi-Fi
OFF ON
Wi-Fi Switch
143