Reconnect To A Wireless Access Point Using The Scansnap Wps Button - Fujitsu ScanSnap iX500 Operator's Manual

Reconnect to a Wireless Access Point Using the
ScanSnap WPS Button
Simply by pressing the WPS button on the back of the ScanSnap, you can easily reconnect
the ScanSnap to a WPS compatible wireless access point.
Perform the following procedures to connect.
ATTENTION
Perform the following before you connect using the WPS button.
If the ScanSnap Wireless Setup Tool is running while the ScanSnap is being connected to the
computer with a USB cable, exit the ScanSnap Wireless Setup Tool.
If scanning is currently being performed from ScanSnap Manager or a mobile device, end the
scanning operation.
HINT
Button names and operating procedures may differ depending on the wireless access point. For details,
refer to the manual for your wireless access point.
1.
Turn on the ScanSnap.
For details, refer to
2.
Turn on the Wi-Fi switch on the back of the ScanSnap.
Wi-Fi
OFF ON
After blinking blue, the Wi-Fi indicator lights up in blue or orange.
Connecting a Mobile Device to the ScanSnap Using Wireless LAN
"Turning the ScanSnap ON" (page
Wi-Fi switch
50
42).