How To Remove Panels - Hoshizaki KMD-460MWH Instruction Manual

• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or storage bin 30" wide or wider.
The following are recommended: Hoshizaki Dispenser, Model DB-200 or DM series;
Hoshizaki Ice Storage Bin, Model B-500 series. For further options, contact your local
Hoshizaki distributor.
• NOTICE! Remote models must be connected to an appropriate remote condenser
unit. The remote condenser unit listed below is recommended. Connection to a
different remote condenser unit will void the warranty unless Hoshizaki approves
a different remote condenser unit for your specific application. For further
details, contact your local Hoshizaki distributor.
Model Number Recommended Hoshizaki Remote Condenser Unit
KMD-530MRH URC-5F
C. How to Remove Panels
See Fig. 1
• Front Panel: Loosen the screws. Lift
up and towards you.
• Top Panel: Lift up at front slightly,
push rearward, and lift off.
• Right Side Panel: Remove the screw.
Slide forward slightly and lift off.
• Insulation Panel (A): Lift up slightly,
and pull towards you.
• Top Insulation: Lift off.
Top Insulation
Insulation Panel (A)
Front Panel
12
Top Panel
Side Frame
Right Side Panel
Fig. 1