Table of Contents
Advertisement
E. Float Switch Check and Cleaning
FS is used to determine that there is sufficient water in the water tank after the 1-min.
fill cycle and after each harvest cycle. FS is also used to determine that the appropriate
volume of water has been converted into ice before switching out of the freeze cycle.
No adjustment is required.
1. Float Switch Check
To check FS, follow the steps below.
1) Remove the front panel, then move the control switch to the "SERVICE" position. Move
the service switch to the "DRAIN" position.
2) Allow the water to drain from the water tank, then move the control switch to the "OFF"
position. Turn off the power supply.
3) Remove the control box cover.
4) Disconnect FS connector from CB K5 (black) connector.
5) Check for continuity across FS leads. With the water tank empty, FS should be open.
If open, continue to step 9. If closed, follow the steps in "II.E.2. Float Switch Cleaning."
After cleaning FS, check it again. Replace if necessary.
6) Reconnect FS connector to CB K5 (black) connector, then replace the control box cover
in its correct position.
7) Move the control switch to the "ICE" position. Replace the front panel in its correct
position, then turn on the power supply. After 1 min., the 1-min. fill cycle should end and
the initial harvest cycle should begin. If the initial harvest cycle begins, FS is good and
the check is complete. If the initial harvest cycle does not begin, continue to step 11.
8) Turn off the power supply.
9) Remove the front panel. Move the control switch to the "OFF" position.
10) Remove the control box cover.
11) Disconnect FS connector from CB K5 (black) connector.
12) Check for continuity across FS leads. With the water tank full, FS should be closed.
If FS is closed and the icemaker will not switch from the 1-min. fill cycle to the initial
harvest cycle, replace CB.
If FS is open, confirm that the water tank is full. If the water tank is not full, check the
water supply, water filters, and inlet water valve. If the water tank is full, follow the steps
in "II.E.2. Float Switch Cleaning." After cleaning FS, check it again. Replace if needed.
Legend: CB–control board; FS–float switch
34
Advertisement
Table of Contents
