Removal And Replacement Of Bin Control - Hoshizaki KMD-901MWH Service Manual

M. Removal and Replacement of Bin Control
1) Turn off the power supply.
2) Remove the front panel and top panel.
3) Remove the control box cover.
4) Disconnect the bin control connector from the bin control wire harness. The wire
harness is connected to the K4 connector on the board.
5) Remove the two thumbscrews securing the switch cover. See Fig. 4.
6) Lift the bin control assembly out of the icemaker.
7) Lift off the insulation, then remove the two thumbscrews attaching the bin control to the
switch cover.
8) Use the thumbscrews to attach the new bin control to the switch cover.
9) Replace the removed bin control parts in the reverse order of which they were
removed.
10) Route the bin control wires the same as the previous bin control and connect the bin
control connector to the bin control wire harness. Replace the control box cover in its
correct position.
11) Replace the panels in their correct positions.
12) Turn on the power supply.
Fig. 4
52
Thumbscrews
Switch Cover
Insulation
Bin Control