Operating The Remote Control - ViewSonic PJ510 User Manual

Operating The Remote Control

ATTENTION
• Do not drop or otherwise expose the remote control to physical impact.
• Do not get the remote control wet or place it on wet objects. Doing so may result in
malfunction.
• Remove the batteries from the remote control and store them in a safe place if you won't be
using the remote control for an extended period.
• Replace the batteries whenever the remote control starts to malfunction.
• When strong lights, such as direct sunlight or light from an extremely close range (such as from
an inverter fluorescent lamp), hit the projector's remote sensor, the remote control may cause to
function. Adjust the direction of the projector to keep light from directly hitting the projector's
remote sensor.
• The remote control works with the projector's remote sensor.
• The range of the remote sensor is 3 meters with a 60-degree
range (30 degrees to the left and right of the remote sensor).
Also a remote signal reflected in the screen etc. may be
available. If it is difficult to send a remote signal to the sensor
directly, please try.
• Since the remote control uses infrared light to send signals to
the projector (Class1 LED), be sure to use the remote control in
an area free from obstacles that could block the remote
control's output signal to the projector.
Remote sensor
approximately 3
meters
ViewSonic PJ510 12