Operating The Remote Control; Using The Remote Id Feature - ViewSonic PJ1172 User Manual

Operating The Remote Control

CAUTION
• Do not disassemble the remote control.
• Do not place the remote control near the projector's lens, fan, or vents.
• Do not drop or otherwise expose the remote control to physical impact.
• Do not get the remote control wet or place objects. Doing so may result in malfunction.
• Remove the batteries from the remote control and store them in a safe place if you
won't be using the remote control for an extended period.
NOTE
• Replace the batteries whenever the remote control starts to malfunction.
• When strong lights, such as direct sunlight or light from an extremely close range (such
as from an inverter fluorescent lamp), hit the projector's remote sensor, the remote
control may cease to function. Adjust the direction of the projector to keep light from
directly hitting the projector's remote sensor.
The remote control works with the
projector's remote sensors.
Front remote sensor is 3 meters with a
60 degree range (30 degrees to the left
and right of a remote sensor).
Rear remote sensor is 3 meters with a 4
degree range (2 degrees to the left and
right of a remote sensor).
Also a remote signal reflected in the screen etc. may be available. If it is difficult to send a
remote signal to the sensor directly, please try pointing it at a different angle.
Since the remote control uses infrared light to send signals to the projector (Class 1 LED),
be sure to use the remote control in an area free from obstacles that could block the remote
control's output signal to the projector.
You can use the remote control as a wired remote control, by connecting the REMOTE
memo
CONTROL port of the main unit and remote control via an audio cable (3.5 dia. Stereo mini
cable with plugs).

Using The Remote ID Feature

This is the function to be used when you operate two or three projectors of
the same type simultaneously. This function should be used combining a
setup of a projector.
Set the ID number to the projector beforehand, refer ring to the item "IR
1
REMOTE ID" of the section "OPTION Menu".
When the ALL is selected to the item "IR REMOTE ID" of the
memo
OPTION menu, the projector is controlled by a remote control
irrespective of the position of the ID CHANGE switch.
Slide the knob of the switch into the position of the ID number of the
2
projector you want to control.
approximately
3 meters
approximately
3 meters
ID CHANGE
switch
ViewSonic PJ1172 11