Power On/Off; Turning On The Power - ViewSonic PJ510 User Manual

Power ON/OFF

Turning On The Power

WARNING
When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector.
NOTE:
Turn the power on/off in right order. Please power on the projector before the connected devices.
Power off the projector after the connected devices.
Make sure that the power cord is firmly and correctly
1
connected to the projector and outlet.
When the lens cap is attached, remove the lens cap.
2
Set the power switch to [ | ] (ON).
3
Power switch (ON position)
The POWER indicator will light orange.
Press the STANDBY/ON button
4
of the projector or the remote control.
The projector lamp will light up and the POWER indicator
will begin blinking green.
According to a setup, the projector lamp may light up and
the POWER indicator may begin blinking green, without
pressing this button.
When the power is completely on, the indicator will stop
blinking and light green.
13 ViewSonic PJ510
POWER indicator
STANDBY/ON button
Power switch
STANDBY/ON button