Table of Contents
Advertisement
Basics
Recommended Paper
R CAUTION:
1
Do not reuse stapled paper. Do not use aluminum foil,carbon-containing paper or other con-
ductive paper. If you do, there is a danger of fire.
Standard paper sizes that can be used in this copier are shown below.
Metric version
A0
A1
A2
A3
A4
Note
❒ When you make a copy on a non-standard size of paper, set the paper in the
bypass tray.
❒ Weight of paper suitable for this copier: 51g/m
❒ Do not use the following kinds of paper or a paper jam might occur.
• Bent, folded, or creased paper
• Torn paper
• Perforated paper
• Non-smooth paper
• Slippery paper
• Thin paper that has low stiffness
❒ Do not make a copy on paper with any kind of coating, such as thermosensi-
tive paper, art paper, aluminum foil, and carbon paper. A fault might occur.
❒ Do not use paper with strong curls at the edges or corners. (Curls rising more
than 5mm (1/4") or falling more than 20mm (3/4") over a 40mm (1.5") radius.)
❒ When you make copies on film, take out the copies delivered to the copy exit
guide one sheet at a time and place them on a flat surface.
❒ If copying to natural tracing paper (all pulp, translucent paper) at a relative
humidity of 35% or less
A
If the paper was left out of its package for 5 minutes or more, remove
the first 1000mm (39.3") before copying.
B
If copies come out wavy or with white spots, use translucent paper in-
stead of natural tracing paper.
C
Always keep the paper in a bag when not using it.
• Store the paper in a sealed polyvinyl bag if not used for a long period.
If it gets humid, paper will curl or wave which can cause a paper jam or
part of the image not to be copied.
8
Inch version
K
E (36"×48")
KL
D (24"×36")
C (18"×24")
KL
B (12"×18")
KL
K
A (9"×12")
Bypass
Roll Feeder
K
KL
KL
KL
K
2
, 14lb to 134g/m
2
, 36lb.
Advertisement
Table of Contents
