Table of Contents
Advertisement
9) Remove the overflow cap and overflow pipe.
10) Remove the drain plug. Allow the water tank to drain, then replace the drain plug in its
correct position. Be careful not to cross thread it.
11) Replace the overflow pipe, overflow cap, cube guide A, and cube guide B in their correct
positions. Be careful not to cross thread the overflow pipe.
12) Reconnect the distributor to the distribution hose.
13) Replace the insulation panel, then replace the left side panel and top panel in their
correct positions.
14) Clean the dispenser unit/storage bin liner using a neutral cleaner. Rinse thoroughly after
cleaning.
15) Move the control switch to the "ICE" position.
16) Turn on the power supply to start the automatic icemaking process.
17) To confirm bin control operation, press and hold the bin control's actuator paddle during
the first 5 minutes of the freeze cycle. The icemaker should shut down in approximately
15 seconds.
18) Replace the front panel in its correct position.
25
Advertisement
Table of Contents
