Table of Contents
Advertisement
Programming
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
3
Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
Handset / Base unit
1
MMENUN#131
R All handsets registered to the base unit are
displayed.
2
MbN: Select the handset you want to cancel.
a MSELECTN
3
MbN: "Yes" a MSELECTN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 4.
Contact your Panasonic dealer for details.
Important:
R Before registering the repeater to this base unit,
you must turn the repeater mode on.
R Do not use more than one repeater at a time.
Setting the repeater mode
Handset
1
MMENUN#138
2
MbN: Select the desired setting. a MSAVEN
a MOFFN
Note:
R After turning the repeater mode on or off,
may be displayed on the handset momentarily.
This is normal and the handset can be used
once
is displayed.
48
Registering the DECT repeater (KX-A405AL/
KX-A406AL) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the DECT
repeater.
1
Base unit:
Press and hold MLOCATORN for about 5
seconds until the registration tone sounds.
R The next step must be completed within 90
seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until the
indicator and
indicator light green.
3
Base unit:
To exit the registration mode, press
MLOCATORN.
R The registration tone stops.
Advertisement
Table of Contents
