Psk Text Memory; Text Message Programming On Tft Screen; Text Message Programming On; Remote Controller - Yaesu FTDX101MP Operation Manual

PSK Text Memory

Five phrases (up to 50 characters each) frequently used in PSK exchanges can be entered into the Text
Memory, either by operation on the TFT screen, or by using the optional "FH-2" Remote Control Keypad
connected to the rear panel REM jack.
5 channels can be recorded. The memory content can be transmitted by operation on screen or the FH-2.

• Text Message Programming on

TFT Screen
1. Press and hold the [MODE] key, then touch
"PSK".
2. Press the [FUNC] key, then touch [REC/
PLAY].
The "PSK MESSAGE MEMORY" screen will
appear.
3. Touch [MEM].
A blinking "REC" will appear in the display.
If no entry is made within 5 seconds, the
registration operation will be cancelled.

• Text Input

1. Enter the letters, numbers, or symbols with
the touch a character keys on the display or
the USB keyboard connected to the USB port
on the front panel.
Use the FH-2 [t] and [u] keys to set the cur-
sor position, and use the FH-2's [p] and [q]
keys to choose the letter or number to be pro-
grammed for each character of the memory.
When the message is complete, add the " "
(touch [End] ) character at the end to signify
the completion of the message.
The following texts are programmed to the
MEMORY 4 and MEMORY 5 in factory de-
fault.
MEMORY 4: DE FTDX101 K
MEMORY 5: R 5NN K
2. Touch [ENT] to exit, once all characters (in-
cluding " ") have been programmed.
4. Touch [1] through [5] to select the desired
PSK Text Memory Register into which the
text is to be programmed.
The text input screen will appear.
5. Continue with "Text Input" below.
• Text Message Programming on
FH-2 Remote Controller
1. Press and hold the [MODE] key, then touch
"PSK".
2. Press the [MEM] key on the FH-2.
A blinking "REC" will appear in the display.
If no entry is made within 5 seconds, the
registration operation will be cancelled.
3. Touch [1] through [5] on the display or press
any of the FH-2 keys numbered [1] through [5]
to select that memory storage register.
The text input screen will appear.
4. Continue with "Text Input".
• On-The-Air PSK Text Message
Playback
Operation on TFT screen
1. Press the [FUNC] key.
2. Touch [REC/PLAY] .
The "PSK MESSAGE MEMORY" screen will
appear.
3. Touch [1] through [5] key, depending on which
PSK Text Memory Register message you
wish to transmit. The programmed message
will be transmitted on the air.
Touch the same number agai n dur i ng
transmission, transmission will be canceled.
Operation with FH-2 Controller
Press the FH-2 [1] through [5] key, depending on
which PSK Text Memory Register message you
wish to transmit.
The programmed message will be transmitted on
the air.
Press the same number again during to immedi-
ately cancel the transmission.
Adjust the data output level using Menu item
[RADIO SETTING] → [MODE PSK/DATA] →
[DATA OUT LEVEL] (page 102).
71