SERVICING YOUR SNOW BLOWER
ENGINE OIL CHANGE
Drain the oil while the engine is still warm to assure rapid and complete
draining.
1. Place a suitable container below the engine to catch the used oil, and then
remove the oil filler cap/dipstick, 10 × 15 mm drain bolt, and sealing washer.
To avoid loosening the 10 × 15 mm drain bolt extension, hold it with a 17 mm
wrench while loosening the drain bolt with a 10 mm box-end wrench.
2. Allow the used oil to drain completely into an approved container, and then
reinstall the 10 × 15 mm drain bolt with a new sealing washer, and tighten it
securely.
TORQUE: 13 lbf∙ft (18 N∙m, 1.8 kgf∙m)
Improper disposal of engine oil can be harmful to the environment. If you change
your own oil, please dispose of used motor oil properly. Put it in a sealed container,
and take it to a recycling center. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.
84
ENGINE OIL FILLER CAP/DIPSTICK
10 × 15mm
DRAIN BOLT
SEALING WASHER
(Replace)