Honda HS1336iAS Owner's Manual page 127

(3)Does not clear snow well.
SYMPTOM
Hard to drive the snow
blower in the forward
direction while clearing the
snow.
Snow does not come out
from the snow discharge
chute.
Hard to collect the snow to
clear.
Blower does not rotate.
Auger does not rotate.
TAKING CARE OF UNEXPECTED PROBLEMS
POSSIBLE CAUSE
Auger shear bolt is broken.
Auger housing height is not adjusted
properly.
Snow is stuck in the auger and the
related parts of the snow blower.
Snow discharge chute is clogged.
Snow is stuck on the auger.
Blower shear bolt is broken.
Drive motor overheated by
operation under excessive load,
which armed the protection
function.
Auger clutch switch or
electromagnetic clutch is faulty.
Auger shear bolt is broken.
Drive motor overheated by
operation under excessive load,
which armed the protection
function.
Auger clutch switch or
electromagnetic clutch is faulty.
REMEDY
Replace the auger shear bolt (see
page 91).
Adjust the auger housing height in
the proper position (see page 50).
Remove the snow from the
underside of the auger housing (see
page 71).
Use the snow clearing bar and
remove the snow from the snow
discharge chute (see page 71).
Remove the snow from the auger
and the related parts (see page 71).
Replace the blower shear bolt (see
page 91).
Release the drive clutch lever and
stop the work. Keep the engine
switch in the ON position and wait
until the drive control warning
indicator (orange) does not blink (see
page 65).
Consult an authorized Honda dealer.
Replace the auger shear bolt (see
page 91).
Release the drive clutch lever and
stop the work. Keep the engine
switch in the ON position and wait
until the drive control warning
indicator (orange) does not blink (see
page 65).
Consult an authorized Honda dealer.
125