Table of Contents
Advertisement
3b. Clearing in POWER mode
With the mode selector switch in the POWER position you can adjust the
engine speed and snow discharge distance. Use the throttle control lever to
adjust the engine speed, which determines how fast snow is picked up and
how far it is thrown. Use the chute control switch to adjust height and
direction of the snow discharge.
• Note that the throttle control lever only functions after the auger is
turning. The engine speed is maintained automatically in POWER mode
(see page 21).
THROTTLE CONTROL LEVER
POWER mode
CHUTE CONTROL SWITCH
RESET SWITCH
(USA model only)
3rd
AUGER HOUSING
CONTROL SWITCH
1) Set the throttle control lever in the third
position from the bottom.
2) Operate the chute control switch to
adjust the snow discharge direction and
angle (see page 27).
3) Operate the auger housing control
switch to adjust the auger to be parallel
to the road surface (see pages 50 and
52).
USA model only:
• You can return the auger to the initial
position by pushing the reset switch.
• If you return the auger to the initial
position by pushing the reset switch, the
auger can hit against the road surface or
can be raised from the road, resulting in
some snow left on the ground,
depending on the road condition and
the position of the snow blower.
Adjust the auger height position as
needed.
OPERATION
57
Advertisement
Table of Contents
