Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
Press TIMER/SLEEP on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™ OFF ™
15 ...
2
When you reach the desired length of time, stop
pressing TIMER/SLEEP.
➜
is shown, except for "OFF" mode.
➜
The sleep timer is now set.
To check the remaining length of time
after sleep timer is activated
●
Press TIMER/SLEEP once.
To change the preset sleep timer
●
Press TIMER/SLEEP again while the remaining
sleep timer is shown.
➜
The display will show the next sleep timer
options.
To deactivate the sleep timer
●
Press TIMER/SLEEP repeatedly until "OFF" is
displayed, or press STANDBY-ON B.
Note:
–
will start flashing when the remaining
length of time after activation of the sleep timer is
less than 1 minute.
pg021-pg044_MCD299-98-Eng-B
37
Clock/Timer
37
2007.9.27, 13:05