Step 1: Connecting Speakers; Step 2: Antennas Connection - Philips MCD299/98 User Manual

Step 1: Connecting speakers

AC CORD
R
SPEAKERS 6 Ω
L
Y/Pb/Pr OUT
A/V OUT
CONNECT TO SUB WOOFER
1
Place the main set with the front side facing
down on a flat and firm surface.
2
Connect the two front speaker cables to the
SPEAKERS (6 Ω) terminals: right speaker to
"R" and left speaker to "L".
3
Remove the detachable cover at the left bottom
of the main set to expose the CONNECT TO
SUB WOOFER terminal.
4
Connect the CONNECT TO SUB
WOOFER terminal of the main set to the
CONNECT TO MAIN SET terminal of the
subwoofer with the supplied 15-pin D-Sub cable
by matching the pins. Fix the two screws on the
connectors to ensure firm connection.
5
Mount the detachable cover back until hearing a
click.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
– The delivery-attached 15-pin D-Sub cable is
intended for use with this system only. Never try it
on any other devices (e.g., do not use it in
connection of your PC).
pg001-pg020_MCD299-98-Eng-A

Step 2: Antennas Connection

Connect the supplied MW loop antenna and FM
antenna to the respective terminals. Adjust the
position of the antenna for optimal reception.
MW Antenna
●
Position the antenna as far as possible from a TV,
VCR or other radiation source.
FM Antenna
●
For better FM stereo reception, connect an
outdoor FM antenna to the FM ANTENNA
terminal.
11
1
2
2007.9.27, 13:04
11