Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The; Step 2: Setting The Clock - Philips MCD299/98 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the Remote Control
3
1
2
1
Open the battery compartment.
2
Insert two AAA batteries following the
indications (+/-) inside the compar tment.
3
Close the cover.
Using the Remote Control to operate
the Player
1
Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2
Do not put any objects between
the Remote Control and the
DVD Player while operating the
DVD Player.
CAUTION!
– Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
pg001-pg020_MCD299-98-Eng-A

Step 2: Setting the clock

The clock can be set in either 12-hour or
24-hour mode.
1
In standby mode, press and hold CLOCK on
the front panel.
2
Press à / á to set the hours.
3
Press í/ë to set the minutes.
4
Press PROGRAM to select clock mode.
5
Press CLOCK to confirm the time.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 90 seconds.
17
Preparations
17
2007.9.27, 13:04