Plug and Play
(for tuner installlation)
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉÅ on the system to start installation.
➜
"PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by MW band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby or demonstration mode, press and
holdÉÅon the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
1
PressÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
●
Press 9 on the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
pg021-pg044_MCD299-98-Eng-B
Switching the system on/off
●
Press STANDBY-ON B.
●
Press DISC, USB, TUNER or AUX on the
remote.
➜
The system will switch to the selected source.
●
Press LEFT ç or RIGHT ç on the front
panel (L ç or R çon the remote).
➜
The system will switch to the disc source.
To switch the system to standby mode
●
Press STANDBY-ON B.
➜
The interactive sound settings, last selected
source and tuner presets will be retained in the
player's memory.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc has stopped playing.
Sound Control
DBB and DSC sound features cannot be
activated at the same time.
DBB (Dynamic Bass Boost)
DBB enhances the bass response.
●
Press DSC•DBB on the remote to enable/
disable DBB feature.
➜
Some discs might be recorded in high
modulation, which causes a distortion at high
volume. If this occurs, switch off DBB or reduce
the volume.
DSC (Digital Sound Control)
DSC provides a different type of preset sound
equalizer setting.
●
Press and hold DSC•DBB on the remote
repeatedly to select: FLAT, POP, CLASSIC, ROCK
or JAZZ.
21
Basic Functions
21
2007.9.27, 13:04