Steps
1. Place the touchpad into its slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the touchpad to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
4. Connect the touchpad Flexible Flat cable to the connector on the system board and close the latch.
5. Place the touchpad bracket on the touchpad.
6. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
7. Replace the three (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
8. Connect the hard drive cable to the connector on the system board.
Next steps
1. Install the
3-cell battery
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
or
4-cell battery
(whichever applicable).
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
85