Steps
1. Connect the battery cable to the connector on the battery.
2. Close the latch on the battery cable connector to secure it to the battery.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
M.2 solid-state drive
Removing the M.2 2230 solid state drive
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid state drive installed.
NOTE:
The M.2 card installed on your computer depends on the configuration ordered. Supported card configurations on
the M.2 card slot:
● M.2 2230 solid state drive
● M.2 2280 solid state drive
The following images indicate the location of the M.2 2230 solid state drive and provide a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
27