Gdo Type - Genie GCL-MJ Manual

GDO and Display Firmware
1. Press CAL/RUN to enter CALIBRATION MODE.
2. Press SCROLL until display reads GDO V# > #####. FIG. 8.
• This display will cycle between the version number of the current GDO firmware and the current
display firmware.
3. Press CAL/RUN to return to RUN mode.
GDO V# ######
CAL
RUN

GDO Type

This operator is available for use in JACKSHAFT configuration only. However, the same control board is used
for jackshaft and trolley models. Service replacement boards need to have GDO TYPE set for the appropriate
model configuration.
NOTE: The GDO type is factory set. The installer should not have to set this feature. However, if the GDO type is
inadvertently changed, or if a board needs to be replaced in the field, follow these instructions to set GDO type.
1. Press CAL/RUN to enter CALIBRATION MODE.
2. Press SCROLL until display reads GDO TYPE >. FIG. 9.
• This will display the current GDO type.
3. Press SET/CLEAR until display indicates correct GDO TYPE.
4. Press CAL/RUN to return to RUN mode.
Sec-4.12
Section 4: Programming
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
FIG. 8
GDO TYPE
CAL
RUN
FIG. 9
DISPLAY V# ####
CAL
RUN
OPEN
JACKSHAFT
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL