Electronic Function - Makita PV001G Instruction Manual

Speed adjusting dial
The rotating speed can be changed by using the speed adjust-
ing dial on top of the switch handle. Turn the speed adjusting
dial to align the pointers with your desired rotating speed indi-
cated on the speed scale. The rotating speed can be adjusted
from 600 (RPM) to 2,200 (RPM), and a target speed can be
obtained when the switch trigger is fully squeezed.
2
3
Fig.5
► 1. Speed adjusting dial 2. Pointer 3. Speed scale
NOTICE:
If the tool is operated continuously
at low speeds for a long time, the motor will get
overloaded, resulting in tool malfunction.
NOTICE:
The speed adjusting dial turns between
600 and 2,200 on the speed scale. Avoid turning
the dial back and forwards further as it may cause
damage to the tool.
NOTE: Be sure to read numbers on the scale as an
indicator since the actual speed may fluctuate slightly.
Shaft lock
Press the shaft lock to prevent spindle rotation when
installing and removing accessories.
1
Fig.6
► 1. Shaft lock
NOTICE:
Never actuate the shaft lock while the
spindle is moving. The tool may be damaged.
Accidental restart preventive function
If you install the battery cartridge while pulling the
switch trigger or locking the switch trigger, the tool does
not start. To start the tool, release the switch trigger, and
then pull the switch trigger.

Electronic function

The tool is equipped with the following electronic func-
tions for easy operation.
Constant speed control
Possible to get fine finish, because the rotating speed is
kept constant even under the loaded condition.
Soft start feature
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
ASSEMBLY
switched off and the battery cartridge is removed
1
before carrying out any work on the tool.
Installing loop handle
both hands, positioning one hand on the switch
handle and the other on the loop handle, side grip
or tool head.
installed securely before operation.
1.
ing the tool head through the loop of the handle.
Fig.7
► 1. Loop handle 2. Tool head
9 ENGLISH
CAUTION:
Always be sure that the tool is
CAUTION:
Be sure to hold the tool firmly with
CAUTION:
Make sure that the loop handle is
Place the loop handle over the tool head by pass-
2 1