Table of Contents
Advertisement
800-357-104-01, Revision 01
Enabling Alarms for Systems Using an HXU-359 Multiplexer
Step
Procedure
1
From the Shelf Options screen, press
appears:
Which Line Unit do you want to change the alarm settings
on (1-28). (E)nable All, (D)isable All
2
Enter the slot number of the line unit you want to enable. When you enter a slot number (x), one of
the following prompts appears.
Do you want to ENABLE alarm settings for Line Unit x (Y/N)
Do you want to DISABLE alarm settings for Line Unit x
(Y/N)
3
Press an appropriate
4
If you plan to install a test card, proceed to
If you plan to install a cut-through card, proceed to
on page
70.
The Wideband System 3190 should now be operational. If you experience any difficulties at this
time, refer to
"Troubleshooting and System Testing" on page
? ? ? ?
Installer Signature
HMS-357 List 4 and List 5
A
to select Alarm Management. The following prompt
Y
N
or
response for the alarm setting you are changing.
"Installing a Test Card (HTC) (Optional)" on page
"Installing a Cut-through Card (HCC) (Optional)"
September 29, 2000
69.
67.
Installer Check ü ü ü ü
H
H
H
H
Date
65
Advertisement
Table of Contents
